Tips (might be useful)

[Little Mick]

Or not, anyway.

Turntable with a felt mat, use double sided tape.

Ebay list with paypal, do postage and finish auction early Sunday evening.

Regards

Stuart

[Little Mick]

When changing CD lasers don’t forget to remove the shorting link.

[andrew ivimey]

When considering changing lasers on cd players, carefully dust the lens first and you might not need to change it.

[Little Mick]

Strain relief grommets

When fitting why not pre tension in a vice or a like for about 10mins before assembly.


When a magnetic bit wont do blue tack might or those old paper wax caps.

[colin.hepburn]

Tip for twisting Valve heater wire thread wire though a key as type found on corn beef tin insert key in drill chuck attach both end of the wire in the vice run drill on slow speed wire is wound nice and tight good job

[russell allen]

Don't waste money on expesive binoculars, simply stand closer to the object you wish to view.




































This was originally a Viz "top tip"

regards

Russell Allen

[John T]

Originally Posted by colin.hepburn2

Tip for twisting Valve heater wire thread wire though a key as type found on corn beef tin insert key in drill chuck attach both end of the wire in the vice run drill on slow speed wire is wound nice and tight good job

Is this correct? I was told never to over tighten the twist. Wires should be loosely twisted in order to facilitate maximum phase cancelling.

[cjnuk]

Originally Posted by Little Mick

When changing CD lasers don’t forget to remove the shorting link.

What link please? What happens if it's not removed? Thanks.