|
Register | FAQ | Members List | Calendar | Gallery | Today's Posts | Mark Forums Read | Search |
Amplifiers Your DIY amplifier designs |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Low noise HT - non BG!
In response to comments for a non BG version of the low noise psu I knocked this version up. Changes are to replace the RC stage with an LC stage since standard caps in the PSU are noisier than chokes and so hide its self noise. The choke is snubbed by two 100nF caps connected to ground from each end of the choke. The big electrolytic is bypassed with a nice PP cap and the output cap is a nice PP of about 10uF. This a nice quiet supply and is the one I use in guitar amps. Again note the balanced power connection on the mains side - it really does make a difference as long as the earth is clean.
ciao James |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
klpp1+k5881mkii noise reduction? | jdrake | WAD Problems | 9 | 19th November 2006 09:11 PM |
The Agony of Surface Noise | Primalsea | Sources | 50 | 10th November 2006 10:28 AM |
KEL84 rustling/crackle noise | richardcarter | WAD Problems | 7 | 22nd September 2006 07:29 PM |
noise | vitalstates | Amplifiers | 2 | 12th September 2006 12:42 PM |
Turntable Signal to Noise Ratio | Primalsea | Sources | 20 | 21st July 2006 08:10 AM |