Kit 6550 refurbishment, guidance please. Help

[tonyo]

Hi,
My first time finding this forum, hello everyone. (thank you to Matthew, I'm very pleased to have read though what I can find)

I have pulled my Kit 6550 out of retirement (13 years under a bed due to young hands damaging valves) alongside my Nkoe Tjoeb 4000. It will be driving PMC FB1's of the same retirement vintage.
This amp was built exactly to spec in 2002, and was used for probably a couple of years. It is going to need cosmetic work and electrical work.
For a start I have some corrosion in the ECF80 valve bases, that will need replacing.
I powered up the amplifier for the first time a couple of weeks ago and was gently reminded of one or two of the few probelms it had : rectifier valve flash over, and quite a physical hum from the power supply. Both of these points had been there since new.
So: I'm going to bite the bullet and refurbish, as a welcome therapeutic project.
All of my three tag boards are working as far as I can see. The laminations on the transformers need to be cleaned and repainted, along with the case. So the whole amplifier is going to be dismantled, and rebuilt from scratch. Orignal tagboards removed (kept safe)and replaced with a new builds.

Here are my plans: please feel free to point me in better direction
1.I have a complete set of Kiwame resistors purchased from Octave electrical in Malaysia in 2002 that I never got to trying out: are they worth building with , considering 20 years ago they were quite respected. Have they been superceded by a different philosophy?
2. PSU capactor upgades, to tackle the hum.
3. ECF80 heater supply: bridge to be replaced with fast diodes.
4. Consider 622S/EY500 recifiers, or at least series anode resistors to 5U4 if not changed.
5. Capacitor upgrades throughout. This is the can of worms I know. This is where your advice will be really appreciated, as I don't really want to spend a fortune if not rquired, but happy to buy right to start with. I was intending years ago to buy WAD upgrade capacitor kis of Jensen PIO and Blackgates, but did not get that far.
6. Alps volume pot (or what else?): possibly shunted through a metal film resistor. Again thoughts please on this resistor if I go this route.
7. I've quite a lot of silver wire (from 20 years ago): If I am rebuilding from scratch, is it really worth wiring the signal path with silver?

I'm not in a rush, so I expect my plans will alter daily until I actually do it, then as you know they can change again. I'm not over concerned with some expensive components if they justify the cost, but buying 'snake oil' audiophile named components for the sake of it is not on the agenda.
Valves: I appear to have quite a collection I don't remember purchasing.
I've various ecf80/e80cf NOS (mullard ecf80 were my first choice) and three sets of 6550. Ive a matched quad of Svetlana, and ElectroHarmonix. Were the originals Sovteck as supplied by WAD?
Thank for your thoughts
Tony