|
Register | FAQ | Members List | Calendar | Gallery | Today's Posts | Mark Forums Read |
Sources Your DIY source designs (turntables etc.) |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Re: Cold cast resin plinth ?
Phil,
I have a load of uncoloured epoxy resin that I was going to coat the paito with and then sprinkle sand on it (non slip surface). Now I have other plans after reading this! You might want to speak to a guy called Ted at Ingilby Mariner in Glemsford (near us). He's very approachable and can sell you the resin quite cheap. He will probably be able to give you loads of advice as well. He's been working with epoxy resins for many years. As for release agent I have been told that the plastic sheeting that florists wrap their flowers in is very good and gives a smooth finish too. In regards to finish and filling it with glass beads or whatever, why don't you go a la novelty toilet seat.
__________________
Paul _______________________________________________ Don't settle for Shampoo, Demand REAL POO! _______________________________________________ |
#12
|
||||
|
||||
Re: Cold cast resin plinth ?
Hi-my posts on this subject were June/July 2006 !
At the time it seemed a good idea but i have moved on now. It would seem that slate is the way to go,as long as one is aware of the health hazards of working with it. Philip
__________________
Philip. Everything in this post is my honest opinion based on what i thought I knew at that very moment in time. |
#13
|
|||
|
|||
Re: Cold cast resin plinth ?
Ah, yes,
I just noticed that. Seems like a good idea though all the same.
__________________
Paul _______________________________________________ Don't settle for Shampoo, Demand REAL POO! _______________________________________________ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lenco GL75 plinth? | Deco-Doctor | Sources | 12 | 9th December 2006 12:34 PM |
Garrard 401 plinth project | Greg. | Sources | 210 | 12th September 2006 12:32 AM |
Lenco plinth project | soulminer | Sources | 367 | 27th August 2006 08:21 PM |
Twin Tier 301 Slate Plinth | Darren D | Sources | 68 | 11th August 2006 01:57 AM |
Garrard 301 Stone Audio Plinth | Darren D | Sources | 2 | 22nd July 2006 02:32 PM |