Chrome knobs

[NealG]

Yes, excellent quality. If you need the hole slightly larger for the selector and mains switch simply run a 1/4" drill down the hole to a depth of 18mm and they will fit perfectly.

For those who don't like them you could always buy some of these!!

[pre65]

Hi-while i have no doubt that they may make a difference-HOW MUCH ?

Philip

Originally Posted by NealG

Yes, excellent quality. If you need the hole slightly larger for the selector and mains switch simply run a 1/4" drill down the hole to a depth of 18mm and they will fit perfectly.

For those who don't like them you could always buy some of these!!

Ha ha ha, $500 for a pair of wooden knobs!!!
Thats up there with the greatest of scams

[KennyK]

Originally Posted by NealG

Yes, excellent quality. If you need the hole slightly larger for the selector and mains switch simply run a 1/4" drill down the hole to a depth of 18mm and they will fit perfectly.

thanks for the tip Neal.

went looking for a 1/4" drill bit in B&Q at the weekend... is anyone surprised that they only stock metric? (I did find some imperial in a lock-n-load set, but some light-fingered-larry had scrumped a couple out of the box. And in a fit of mean-ness I deceided I wasn't paying £15 for the last half-set of bits.)
will need to see if my mate at MachineMart has some. else it's buying off the web and the ensuing crazy carriage charges that small orders attract.

[NealG]

Well 1/4" is 6.35mm so I think a 6.5mm would have been OK