|
Register | FAQ | Members List | Calendar | Gallery | Today's Posts | Mark Forums Read | Search |
Wish List Poll your project wishes here |
View Poll Results: Should Kel84 be part of the WD range? | |||
Yes - as a pcb kit for newcomers | 3 | 25.00% | |
Yes - as a hardwired kit for older hands | 0 | 0% | |
Yes - both pcb and hardwired options | 7 | 58.33% | |
Yes - but make it hardwired and valve rectified | 2 | 16.67% | |
No | 0 | 0% | |
Voters: 12. You may not vote on this poll |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Kel84
Should Kel84 be part of the range.
|
#2
|
|||
|
|||
Re: Kel84
who has the rights to the designs, Richard?
|
#3
|
||||
|
||||
Re: Kel84
KEL84 or something along the same lines is a must.
An updated KEL84 with some of the mods (bridge rect, slightly lower feedback) would be good. I think to send a decent PCB but include plans for hardwiring would be excellent. Paul |
#4
|
|||
|
|||
Re: Kel84
6v6 Valves for a change!!!
|
#5
|
||||
|
||||
Re: Kel84
6v6 less powerful cooler running not available new afaik.
Kel84 proven excellent design, can't see any obstacles to rehashing it, you can't copywrite a valve amp design with nothing new about it since the Mullard book was published.
__________________
|
#6
|
|||
|
|||
Re: Kel84
Don't know Ian but it wouldn't be hard to redesign as a category of amp if needed. I'm not sure just how different the design would have to be or even if it is covered by rights if it can be shown to have been used before.
For example, a front end and concertina splitter similar to Kel84 is used by Morgan Jones with an ECC88 in his "Practical 10W el84 power amp" and there are probably others using the ecf80. Mullard 5-10 is open-source and spawned similar types such as Leak ST20. The Leak is good so I'd really like to hear the 5-10, which only uses one cap coupled stage, with good OPTXs. Rich |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wad Kel84 | Jack Hawthorne | General | 8 | 5th December 2006 12:20 PM |
Kel84 - Speaker Binding Post Wiring | BL21DE3 | WAD Problems | 17 | 31st August 2006 12:52 PM |
KEL84 & Jupiters: Tolerance: 26% over spec o.k.? | pete_b | WAD General | 4 | 27th April 2006 08:34 PM |
KEL84 Monoblock | Paul Welsby | WAD General | 12 | 11th April 2006 09:57 PM |