|
Register | FAQ | Members List | Calendar | Gallery | Today's Posts | Mark Forums Read | Search |
Sources Your DIY source designs (turntables etc.) |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Pick up Transformer confusion
Today, I received 2 Cinemag CMQEE-3440A transformers. The connections are identified on the datasheet as 37.5, 150, 600. How does this translate into the ratios required. Taking square roots you get roughly 6, 12 , & 24. Is this right or am I all at sea?
Thanks Steve |
#2
|
|||
|
|||
Re: Pick up Transformer confusion
Tweeky
9, 18, 36 are the ratios. Start with the 18 or 150ohm tap. Which cartridge are you using? Their wiring can cause noise....I have a better way of wiring them up which avoids the noise issue. Let me know if you'd like a diagram. Great step-ups. Regards
__________________
Gerry |
#3
|
|||
|
|||
Re: Pick up Transformer confusion
Gerry,
I am using a Dynavector Karat 17d Mk 2 which needs to see a load of >100 ohms and has an output of 0.23 mV. Any clues on how to reduce noise would be appreciated. Many thanks Steve |
#4
|
|||
|
|||
Re: Pick up Transformer confusion
Steve
Here you go. Sorry for the delay it was on my office pc. I just used a tag strip to terminate the wires not used. Regards
__________________
Gerry |
#5
|
|||
|
|||
Re: Pick up Transformer confusion
The black wire connects to the screen and should be
connected to the phono socket if it goes to chassis earth you will loose the screening. |
#6
|
|||
|
|||
Re: Pick up Transformer confusion
Will
It does work as above. Richard at Vantage Audio and I struggled with CineMag's set up due to hum. This is what was settled on with the phono cable as pseudo-balanced, the cable screen going to the earth. No hum, Deadly silent. Regards
__________________
Gerry |