Pre 3

GDay,

Can anyone help with any info in changing to a balanced output for the Pre 3, any drawings knocking about.

Ta
Bruce

[Richard]

Hi Bruce, yes indeedy, here're the XL instructions, this is all part of the present WD range and Matthew will be able to help with parts etc

Many thanks Richard

[bob orbell]

Can I just add that you will need to enlarge the two holes in the PRE III case, to take the small XLR sockets. BOB

[Richard]

Yes, to 11mm diam.

The case is soft aluminium so a taper reamer is best if you have room to use it in the case, http://www.maplin.co.uk/reamer-3869

Otherwise a drill bit held in a handrill chuck etc and rotated against the hole by hand is safest. The existing hole is nearly the correct diam and if you try to use a power drill it will grab violently and may damage the case.

Thanks all, just to add time served my time fitter/tuner.

Regards