|
Register | FAQ | Members List | Calendar | Gallery | Today's Posts | Mark Forums Read | Search |
WD Amplifiers For discusson of World Designs Amplifiers |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Re: Remote volume for the Kel84
Simon, you don't say what you are fitting the remote in, it can be run from 6volt AC, or 9volt DC, what is it going in please, then we can advise. BOB
|
#12
|
|||
|
|||
Re: Remote volume for the Kel84
Sorry Bob, it is in a KEL84, I assume the ECF80 heaters are the starting point as these have the 6.3vdc required.
|
#13
|
|||
|
|||
Re: Remote volume for the Kel84
Simon, I think you need to read the instructions again, I am shure that the HiFi Collective RC Board need's 6.3 volts AC, so you must not connect to the ECF80's as the voltage here is DC, you need to pick up the heater voltage from any EL84, connect any way round, it's not important.
|
#14
|
||||
|
||||
Re: Remote volume for the Kel84
Just run a couple of wires from the heater supply to one of the valves to the board. Or maybe I don't understand your question.
I would pick an el34 socket and solder a wire to pin 4 and another to pin 5 and take these two wires to the remote board.
__________________
Just about everything I say has been in public use since the 1940's so no one owns the copyright on that. If by any chance its not prior art, then the copyright is retained by me. |
#15
|
|||
|
|||
Re: Remote volume for the Kel84
You are spot on Nick.
|